Endüktif Sensör Pepperl Fuchs NBB15-30GM50-WS
Endüktif Sensör Pepperl Fuchs NBB15-30GM50-WS-V12
Endüktif Sensör Pepperl Fuchs NBB15-30GM50-WS-5M
Sensör
Yakınlık Sensörü
Proximity Sensor
Endüktif Proximity Sensör
Inductive Proximity Sensor
Pepperl Fuchs
Pepperl Fuchs Sensör
Pepperl Fuchs Proximity Sensor
Pepperl Fuchs Yakınlık Sensörü
Pepperl Fuchs Endüktif Proximity Sensör
Pepperl Fuchs Inductive Proximity Sensor
Pepperl Fuchs NBB15-30GM50-WS-5M
Pepperl NBB15-30GM50-WS-5M
NBB15-30GM50-WS-5M
Açıklama
Pepperl Fuchs NBB15-30GM50-WS-5M Endüktif Sensör
Pepperl NBB15-30GM50-WS-5M Inductive Sensor
Yaklaşım Sensörü Pepperl Fuchs NBB15-30GM50-WS-5M
Pepperl Fuchs NBB15-30GM50-WS-5M Yakınlık Sensörü
Inductive Sensor NBB15-30GM50-WS-5M Pepperl-Fuchs
Endüktif Sensör NBB15-30GM50-WS-5M Pepperl-Fuchs
Teknik veriler NBB15-30GM50-WS-5M
| General specifications | |
| Switching function | Normally open (NO) |
| Output type | Two-wire |
| Rated operating distance | 15 mm |
| Installation | quasi flush |
| Output polarity | AC |
| Assured operating distance | 0 … 12.15 mm |
| Actual operating distance | 13.5 … 16.5 mm |
| Reduction factor rAl | 0.33 |
| Reduction factor rCu | 0.28 |
| Reduction factor r304 | 0.81 |
| Nominal ratings | |
| Operating voltage | 20 … 253 V |
| Switching frequency | 0 … 20 Hz |
| Hysteresis | typ. 5 % |
| Voltage drop | < 5 V (IL > 50 mA); < 8 V (IL < 50 mA) |
| Momentary current (20 ms, 0.1 Hz) | 0 … 1600 mA |
| Operating current | 5 … 200 mA |
| Off-state current | 0 … 1.7 mA |
| Operating voltage indicator | LED, green |
| Switching state indicator | LED, yellow |
| Standard conformity | |
| Standards | IEC / EN 60947-5-2:2004 |
| Ambient conditions | |
| Ambient temperature | -25 … 70 °C (-13 … 158 °F) |
| Mechanical specifications | |
| Core cross-section | 0.75 mm2 |
| Housing material | brass, nickel-plated |
| Sensing face | PBT |
| Housing diameter | 30 mm |
| Degree of protection | IP67 |
| Note | 1) In the temperature range below 0 °C, permissible operating voltage Ub 80…253 V Safety fuse ≤ 0.3 A (quick-blow) according to IEC 60127-2 Sheet 1 Recommendation: after a short circuit, check that the device is functioning correctly. |
