Ürünler
Ultrasonik Sensör Pepperl Fuchs UCC2000-30GH70-IE2R2-V15
3 Aralık 2018Ultrasonik Sensör Pepperl Fuchs UCC1000-18GH90-E2-IO-V1
3 Aralık 2018
Ultrasonik Sensör Pepperl Fuchs UCC1000-30GM-IUR2-V15
Sensör
Ultrasonic Sensor
Ultrasonik Sensör
Pepperl Fuchs
Pepperl Fuchs Sensör
Pepperl Fuchs Ultrasonic Sensor
Pepperl Fuchs Ultrasonik Sensör
Pepperl Fuchs UCC1000-30GM-IUR2-V15
Pepperl UCC1000-30GM-IUR2-V15
Açıklama
Pepperl Fuchs UCC1000-30GM-IUR2-V15 Ultrasonik Sensör
Pepperl UCC1000-30GM-IUR2-V15 Ultrasonic Sensor
Teknik veriler UCC1000-30GM-IUR2-V15
| Ürün Açıklaması |
| Single head system |
| General specifications | ||
| Sensing range | 80 … 1000 mm | |
| Adjustment range | 100 … 1000 mm | |
| Dead band | 0 … 80 mm | |
| Standard target plate | 100 mm x 100 mm | |
| Transducer frequency | approx. 175 kHz | |
| Response delay | 65 ms minimum 195 ms factory setting |
|
| Indicators/operating means | ||
| LED green | solid: Power-on flashing: Standby mode or program function object detected |
|
| LED yellow 1 | solid: object in evaluation range flashing: program function |
|
| LED yellow 2 | solid: object in detection range flashing: program function |
|
| LED red | solid: temperature/program plug not connected flashing: fault or program function object not detected |
|
| Temperature/TEACH-IN connector | Temperature compensation , Evaluation range programming , output function setting | |
| Electrical specifications | ||
| Operating voltage | 10 … 30 V DC , ripple 10 %SS | |
| Power consumption | ≤ 900 mW | |
| Time delay before availability | ≤ 500 ms | |
| Interface | ||
| Interface type | RS 232, 9600 Bit/s , no parity, 8 data bits, 1 stop bit | |
| Input/Output | ||
| Synchronization | bi-directional 0 level -UB…+1 V 1 level: +4 V…+UB input impedance: > 12 KOhm synchronization pulse: ≥ 100 µs, synchronization interpulse period: ≥ 2 ms |
|
| Synchronization frequency | ||
| Common mode operation | max. 30 Hz | |
| Multiplex operation | ≤ 30 Hz / n , n = number of sensors , n ≤ 5 | |
| Output | ||
| Output type | 1 current output 4 … 20 mA 1 voltage output 0 … 10 V |
|
| Resolution | evaluation range [mm]/4000, but ≥ 0.35 mm | |
| Deviation of the characteristic curve | ≤ 0.2 % of full-scale value | |
| Repeat accuracy | ≤ 0.1 % of full-scale value | |
| Load impedance | current output: ≤ 500 Ohm voltage output: ≥ 1000 Ohm |
|
| Temperature influence | ≤ 2 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) |
|
| Compliance with standards and directives | ||
| Standard conformity | ||
| Standards | EN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 EN 60947-5-7:2003 IEC 60947-5-7:2003 |
|
| Approvals and certificates | ||
| UL approval | cULus Listed, General Purpose | |
| CSA approval | cCSAus Listed, General Purpose | |
| CCC approval | CCC approval / marking not required for products rated ≤36 V | |
| Ambient conditions | ||
| Ambient temperature | 0 … 70 °C (32 … 158 °F) | |
| Storage temperature | -40 … 85 °C (-40 … 185 °F) | |
| Mechanical specifications | ||
| Connection type | Connector plug M12 x 1 , 5-pin | |
| Degree of protection | IP65 | |
| Material | ||
| Housing | Stainless steel 1.4305 / AISI 303 O-ring for cover seal: Viton |
|
| Transducer | PTFE (diaphragm surface) | |
| Mass | 170 g | |
| Factory settings | ||
| Output | evaluation limit A1: 100 mm evaluation limit A2: 1000 mm rising ramp |
|
